Видео

Do u have to have Internet to use this?

Thank you so much, you saved my life!😊

Remember to turn the valve on your propane tank slowly!

A bottle of Chateau Lafite Rothschild Pauillac for the young lady!!

Petrol then soap water to wash the petrol off

Great job really like the camera angles really shows what your tractor is doing when moving material.

Thank you very much for your help. You are cool and explained everything perfectly.

That looks like a 30 amp box. Are you using a 30 amp box with 10 wire and 30 amp fuses in your electrical panel? And that handles that size generator without any dangerous problems in your electrical box or wiring?

It worked, at least for now. Some of the comments say that it works for a little while and then has problems again so we'll wait and see!

Good video. I replaced both parts. Temperature went from the mid 70's in both compartments to 51 on top and 62 on bottom. Neither temperature has gotten any cooler after 24 hours. The fan has already been replaced and is working. The compressor is running but does feel hot. Not sure what other part could be not working.

Very informative video!!! Did your home come with that power outlet set up for the generator or did you do that yourself? If so what does that cost roughly?

hahaha the can says to use soap and water which does nothing lol

Mine is a Magic Chef MCBC580DBT 2582 Not the same model as yours, but looks similar. Do you think both parts are needed? Or just the black one?

M-F = Mighty- Fine tractors. Nice Job.

That thing is really loud

Hello, Are you interested in testing our products? We would like to invite you to test the Heavy Duty Rear Windshield for your OLARIS RANGER CREW 900( if your car year is 2013-2019)

Holy crap, what a life saver, thank you

Ever had to level it? I can’t figure out how the front is adjusted

Has he tried acid based cleaners for the brake dust on the wheels?

Well what seals the pipes to the muffler?

I have a similar problem. My compressor does not run although everything else seems to be fine. I have measured the voltage supplied to the compressor (red and blue wires) and measured essentially zero voltage. since where I measured is electrically "ahead" of the two parts you replaced, it seems my problem is not with these two parts. If the wine fridge senses a problem and does not power up the compressor, and would send power if the two parts are replaced, then replacing the parts would fix my problem. But this seems unlikely. Could you tell me if you measured the voltage across the two wires that carry power to the compressor/relay/overload assembly? Thanks Tom

I just ordered the parts. Has this repair held up for all that have replaced these parts?

Unfortunately, it does not work for foam glue like pond foam glue. I’m on day two use probably a whole bottle of acetone. Going to Lowe’s to get goof off.

Nice Job I tell you made me laugh with light switch

So many positive feedbacks on this video. I also found the explanations kinda easy to understand. Wondering if we can apply it to a GE profile wine cooler which stopped cooling after a massive power outage. Or is it not advisable since the video is meant for Magic Chef. A novice here, so quite frankly, am anxious

I've had the exact same generator that you have for about 4 yrs now. Haven't had any trouble with it till lately. Pulled it out to start it and run it just to make sure it was still in good running order and it will not start. I only run it on propane and can't understand why it won't start. Last tried it a few weeks ago during some warm weather we had. Nearly got it going after both push button and pull cord attempts. It sputtered a few times, but that was it. Couldn't get anything more out of it and I was running the battery down using the push button start. Watching your video, I suddenly remembered I got that same battery charger and now have to find it to charge that battery up. Hope I didn't accidentally throw it away thinking it was from something else I don't have anymore. Same with the key fob. Has to be around here somewhere. Waiting for warmer weather to come to try it again, but I better hunt for the charger. Not to worried though, I also have 3 Eco Flow solar gens that work great. Still nice to have the Westinghouse though.

how long does it run on that size porpane tank ?

I replaced the pvc pipe inside the sand filter when I put it back in how far should I put it into the top black piece? If you would happen to know and let me know I’d appreciate it!

Thank you! Was ready to buy a new unit then my wife found this video. Ordered parts on Amazon and next day the fridge was working again. Great video!

Two concerns I want to share with you. It is plain that you used Non Metallic Sheathed cable, commonly called by it's first manufacturers brand name for it which is Romex, to make that connection cable. The possible consequence of using that cable is that the wires themselves are solid. Unlike the fine stranded wire in a cord it is more likely to fatigue and break do to the vibration of the generator. You need to size the wire in that cord for the ampacity of the generator's main breaker. If for any reason more current than the generator can produce for a long time was flowing through that breaker it would open on the overload and prevent the generator or it's ampacity matched cord from being damaged. Yes that the gauge of cord which matches the generator's ampacity Is likely to be expensive when compared with Romex but there is a way around that. Install the inlet box on a post made by burying the end of a pressure treated 4X4 in the ground. You will need to dig a trench for Underground Feeder (UF) cable or Underground Service Entry (USE) cable which are suitable for direct burial. Cable must be buried 2 foot deep to it's upper side. Use whichever one is the least expensive there. You can also use PVC Non Metallic Conduit (NMC) and pull THHN-THWN individual wires into it. That only needs to be 18 inches deep to the top of the conduit so it's a little less digging. Mount the inlet high enough above the ground so it is easy to plug into. 4 feet up will make it much easier to see the inlet plug to insert the cord connector over it. You may want to place a yellow mark on the cord connector, that is what the receptacle end of a cord is called, and a yellow mark on the inlet connector so that it is easier to insert the connector into the male inlet when setting up. You may also want to put a green mark were the yellow mark is on the cord connector when it has been plugged in and turned to lock it in the inlet. Yellow mark to yellow mark to insert and yellow mark to green mark when it is locked in position to prevent pull out. The colors are not important use any colors that suit you. Those were just examples. Why am I saying you should put the inlet 30 feet away from the house? Because 25 feet is the absolute minimum separation from the home that any generator should be operated to be sure that Carbon Monoxide will not infiltrate into the house and kill you and your family. If the generator is at least 25 feet from the house you don't have to worry about CO infiltration. Even with 25 feet of separation make sure that you have working CO detectors that also detect propane gas getting inside your house. If enough propane accumulates it will reach an explosive concentration by mixing with the air in the house to propane's lower explosive limit. Propane is heavier than air. When it leaks it flows across the ground like invisible gasoline. It will accumulate in the lowest space it encounters. Basements that have not been externally waterproofed are vulnerable to propane infiltration. External water proofing as a building code requirement is a relatively recent requirement. Tom Horne

Sand paper. Honestly, best never to touch this shit without gloves, but if you’re seeing this, you probably figured that out by now.

Thank you for making this video. Can you tell me what all yours can run at once?

What is the parts e.ail address

Thanks, very helpful.

Our Magic Chef is alive and well thanks to your video! 🍷🍸🥂

Do you have a transfer switch so there will be no backfeed?

This Westinghouse inverter generator is VERY HARD TO START during Winter Season/Cold weather..... but In other Seasons is good to Start. I think I will change back to Champion inverter generator soon EASIER TO START during Winter Season 👍👍

Thank you, thank you!

Did you hook up the plug and breaker for your generator yourself to the panel and the interlock .

I’ll give u $2.12

So what is the other $180 for?

It does not remove it, specially Pattex brand. I got it covering my hands like a cast, not just few pieces

Thank you for sharing your experience. I was thinking of buying a new wine cooler but your video saved me. Ordered the parts and my wine cooler is working thus far.

Work like a charm🍻

Great video! It worked for me too. Glad I found this video before running to HomeDepot to grab an expensive replacement fridge

hi... time of autonomy with it?

I replace both parts there and still turns on but doesn't cool

Very helpful! Worked perfectly. I was really struggling with this thing until I watched this. Thank you!!

Well I just found one haven't tried it out as yet but the inside looks brand new and also smell brand new inside I think I found a good one. Until I seen your video now I know what I have